|
Post by remrat on Sept 11, 2010 19:35:24 GMT -5
Hi guys i just made a Hfc134a gas rig for my Marushin garand it cycles fine and the bolt operates perfectly but the bb's get lobed only 15 or so feet what do i do about this. iv also considered the hole in the barrel of the garand s and was wondering if I could fill the hole in to help with the fps or will that ruin the bb's accuracy.
Thanks.
|
|
kalbs
Master sergeant
Posts: 1,142
|
Post by kalbs on Sept 12, 2010 0:28:28 GMT -5
I have no idea what you are talking about with filling a hole? Take some photos. You have an air leak somewhere but don't fill anything that suppose to be there
|
|
|
Post by Gordak on Sept 12, 2010 8:50:01 GMT -5
marushin garands can shoot pretty good, but require a fantastic balet of lubrication and locktite. If it's shooting 15 feet, something is wrong. good luck with that.
|
|
|
Post by remrat on Sept 12, 2010 16:22:01 GMT -5
ok discard that other problem i fixed that then i took the gun completely apart then back together now when i shoot the blow back works but no gas gets to the bb so the bb just stays in the chamber and every shot the gun loads a new bb
|
|
|
Post by remrat on Sept 12, 2010 18:17:21 GMT -5
nvm problem fixed thx guys
|
|
|
Post by remrat on Sept 12, 2010 20:14:42 GMT -5
ok the gun works fine now just wondering is there a way to up the fps on 134a in any way. and dont marushin garands have a curve in the barrel and a hole in the barrel here is were i heard of the curve and hole: www.youtube.com/watch?v=F0OXidk7e28
|
|