Post by grifter on Oct 16, 2016 6:12:39 GMT -5
Hello,
Here is a custom achievable by any amateur handyman just asking an aesthetic modification of the whole.
Allows a semi auto playable German side over a wide period.
Start:
End point:
Exhibit necessary:
_M14 Wooden stick
_short magazine M14
_front and rear K98 "shoetree"
_Rear sight K98
but not required additional room:
_handlebar protected
_Butt platte
Being jealous of the digging tool butts Droopaille, I abandoned the idea of buying a rifle G41 and adaptation of mechanical M14.
So I went on the butt of an M14 that I modified with wood filler to resemble the more ready than the G41.
For this filling holes strap rings, the butt plate.
Addition of pulpwood for the tilt of the hand guard.
Manufacturing / addition of a wooden extension fitted to the front of the stick between 2 "shoetree", the butt of the M14 being far too short.
Photo close, becarefull (it stings the eyes ...)
_PVC parts holding the 2 "shoetree".
_The 2 upper hand guards are also in deformed PVC / reformed
_The Barrel is made from an M870 tube drop, tip made with two component paste.
_Made it / body sculpting covered in a Teflon fall.
![]()
Then cylinder head, bolt, bolt handle and rear sight holder also made deformed PVC, all the parts glued together to not form a single piece of a piece.
Reduced fire selector and grip the magazine (to try to be discreet + possible).
All attached to the M14 by:
_ The side screws on the left side M14
_a screwed through the body of sight and connected to a countersunk hole on the thickest part of the barrel of the M14.
The aesthetic is very perfectible but gives a correct print I think.
Just be that I find a system allowing me to spend my semi lever / useful burst if blocked the semi.
Here is a custom achievable by any amateur handyman just asking an aesthetic modification of the whole.
Allows a semi auto playable German side over a wide period.
Start:
End point:
Exhibit necessary:
_M14 Wooden stick
_short magazine M14
_front and rear K98 "shoetree"
_Rear sight K98
but not required additional room:
_handlebar protected
_Butt platte
Being jealous of the digging tool butts Droopaille, I abandoned the idea of buying a rifle G41 and adaptation of mechanical M14.
So I went on the butt of an M14 that I modified with wood filler to resemble the more ready than the G41.
For this filling holes strap rings, the butt plate.
Addition of pulpwood for the tilt of the hand guard.
Manufacturing / addition of a wooden extension fitted to the front of the stick between 2 "shoetree", the butt of the M14 being far too short.
Photo close, becarefull (it stings the eyes ...)
_PVC parts holding the 2 "shoetree".
_The 2 upper hand guards are also in deformed PVC / reformed
_The Barrel is made from an M870 tube drop, tip made with two component paste.
_Made it / body sculpting covered in a Teflon fall.
Then cylinder head, bolt, bolt handle and rear sight holder also made deformed PVC, all the parts glued together to not form a single piece of a piece.
Reduced fire selector and grip the magazine (to try to be discreet + possible).
All attached to the M14 by:
_ The side screws on the left side M14
_a screwed through the body of sight and connected to a countersunk hole on the thickest part of the barrel of the M14.
The aesthetic is very perfectible but gives a correct print I think.
Just be that I find a system allowing me to spend my semi lever / useful burst if blocked the semi.
