|
Post by volkssturm on Dec 24, 2013 18:35:40 GMT -5
I'll have to resurrect that project one of these days. The short M14 mags are a good idea. I wasn't real happy with converting shotty mags. Too finicky and too few shots. I got side tracked on a VZ24 project that's about half way done. I'm trying to figure out how to undo the damage I did to my VSR or just buy another one. I had a real brain fart at one point and drilled some holes where there shouldn't be holes.
|
|
|
Post by volkssturm on Dec 24, 2013 18:36:41 GMT -5
Double post.
|
|
2nd Bat
Master sergeant
Posts: 11,813
|
Post by 2nd Bat on Dec 24, 2013 23:47:50 GMT -5
Volks, what part of your BAR 10 did you mess up. i may have a replacement part from a project where I screwed up a different part. Send me a picture via PM and if I have something to replace it with I'll send it to you. I have a few skeletons from VSR Rifles. Victims of wrong turns or dead ends I ran into.
|
|
|
Post by volkssturm on Dec 25, 2013 0:56:42 GMT -5
Drilled a hole through the receiver into the cylinder. Don't know what I was thinking. Evike has replacements so I'll probably pick one up from them.
|
|
2nd Bat
Master sergeant
Posts: 11,813
|
Post by 2nd Bat on Dec 25, 2013 2:41:29 GMT -5
Give me your address via pm and i'll snd you one.
|
|
2nd Bat
Master sergeant
Posts: 11,813
|
Post by 2nd Bat on Mar 24, 2016 16:41:52 GMT -5
Sad note to this thread. Jettalewis went in for open heart surgery shortly after completing this project and never again posted to our site. Efforts on my part to contact him went unanswered and his hosting site for the tutorial pictures was closed.
Frankly I fear the worst. His contributions were fabulous and his efforts much appreciated. He will be missed!
|
|