|
Post by LϟϟAH1944 on Sept 13, 2012 19:57:53 GMT -5
Is there any way to remove the stock from AGM's MP40? Im *attempting* to convert it to an mg42.
|
|
|
Post by Schmozilla on Sept 13, 2012 20:16:29 GMT -5
There's little round bits holding the stock in, mine are always becoming loose but you can take it off but not fully, there's a little tube sticking out
|
|
|
Post by LϟϟAH1944 on Sept 13, 2012 20:46:12 GMT -5
any way, even if it damages the stock?
|
|
|
Post by kingraptor141 on Sept 14, 2012 20:10:48 GMT -5
If you take out the pin the big button just falls apart and everything with it. The big end cap that the upper receiver slides into can be removed by removing two small screws in the end.
|
|
|
Post by LϟϟAH1944 on Sept 15, 2012 0:18:10 GMT -5
How does one take out the pin?
|
|
|
Post by kingraptor141 on Sept 16, 2012 14:12:28 GMT -5
With a small (I think mine is 3mm) punch and hammer.
|
|
|
Post by LϟϟAH1944 on Sept 18, 2012 17:52:44 GMT -5
AAh, thanks! I will do that.
|
|